PEEK, PEI, the sulfones and the materials most shops avoid. In-line crystallization and stress relieving are the capability set Jonathan spent twenty years building.
Experience
Jonathan's high-temperature work goes back to International Polymer Engineering, where he worked on high-temperature extrusion across medical, aerospace and additive manufacturing. At Spectrum Plastics Group, formerly Apollo Medical Extrusion, he introduced high-temperature capability and developed the process to fully crystallize PEEK tubing during extrusion. By the time he published his Spectrum papers as Senior Extrusion Engineer, his extrusion focus for more than ten years had been high-heat materials such as PEEK and other exotic, difficult-to-extrude materials.
He has published on the subject as white papers and conference talks: how to choose an ultra-engineering polymer for an extruded medical part, how crystallinity changes PEEK performance, and how materials more rigid than PEEK compare when extruded as tubing.
The problems we solve
These resins process hot: roughly 350 to 400°C for the sulfones and 360 to 400°C for PEEK, with PEI below PEEK. PEEK runs near 700°F (about 370°C) and needs extruders with higher-powered heaters and low-thermal-expansion construction. The common failure points:
- Choosing on Tg or melt point alone, then finding the resin behaves differently through the die and quench
- Under-dried resin: all three families are hygroscopic, which shows up as bubbles, splay and molecular-weight loss
- Under-crystallized PEEK that passes inspection, then cracks, shrinks or goes oval in sterilization or use
- Amorphous PEI or sulfone parts that stress-crack in service against certain solvents
- Paying for PEEK when a sulfone or PEI would meet the thermal and chemical demand
In-line crystallization
Datasheet values for PEEK come from fully crystallized samples. In the crystallinity study listed in Jonathan's publications, tubing made the same day on the same line and tooling was tested amorphous, crystallized in-line, and annealed afterward in an oven. Both crystalline routes beat amorphous tubing on flexural load and modulus, and the in-line tube had more than twice the elongation at yield of the oven-annealed tube. Fully crystallized should be the default for PEEK extrusions, and in-line crystallization avoids the mandrels, wires and fixtures a secondary anneal needs. Whether a given tube can be crystallized in-line depends on size, geometry and line speed, and working through those variables is the processor's job.
Material selection
The real decision is rarely which polymer is best. It is which polymer meets the part's thermal and chemical demands at a cost and processability you can run. Jonathan works across PEEK, PEI and the sulfones by service temperature, chemistry, sterilization path and cost, and has studied stiffer options including PEKK and glass-reinforced grades.
How to start
Bring your part, your sterilization path and your line, and think it through with Jonathan before tooling is cut. Book a 30-minute intro call or send a note. You'll hear back from Jonathan directly.
Related materials
Related reading
Have a part, a material question, or a line to scope? Book a 30-minute call with Jonathan or send a note.
