Pebax, TPU, highly crystalline materials and engineered polymers for delivery systems. Material-to-process correlation, especially around substitution and supply.
Experience
Correlating unfamiliar materials with familiar processes is where Jonathan's medical career started. At International Polymer Engineering, his entry into medical extrusion, that meant learning a new polymer vocabulary and materials research. He later wrote the white paper on choosing ultra-engineering polymers for extruded medical parts, and at Spectrum Plastics Group he published an in-house study that extruded and tested tubing in PEEK, PEKK, glass-reinforced polysulfone and polyarylamide, and a liquid crystal polymer.
Why teams look at a material change
Most substitution projects start with one of three pressures. Cost: resin pricing and tariff activity push teams to qualify alternate grades. Supply: a single-source grade on a long lead time is a risk on its own. Performance: a design may need more distal softness, better hydrolysis resistance or a different stiffness gradient. Any of these can justify a look. None justify skipping the work.
The problems we solve
- Treating Pebax and TPU as drop-in equals, then losing torque transfer when a TPU softens in the body
- Choosing on datasheet values that do not match the part's real conditions
- Drying and melt-profile changes that quietly fail a switch on the line
- Assuming biocompatibility carries across grades; it is grade-specific
- Pricing the pellet instead of the whole path, since any resin change triggers revalidation
How a correlation project runs
Start with property correlation: map the current material's real requirements, not its datasheet, against candidate grades: effective stiffness at body temperature, kink radius, burst or column strength, and the sterilization and fluid exposure the part sees. Run small-batch extrusion trials on production-representative tooling and dial in drying, melt profile and line speed. Close with dimensional and performance checks: OD, ID, wall and concentricity, then kink, tensile, burst and bond compatibility side by side against the incumbent. Done this way, you either qualify the substitution with evidence or kill it cheaply, before it reaches a build.
How to start
If you are weighing a substitution, Jonathan can help correlate the properties, run the small-batch trials and validate the results before you commit. Book a 30-minute intro call or send a note. You'll hear back from Jonathan directly.
Related materials
Related reading
Have a part, a material question, or a line to scope? Book a 30-minute call with Jonathan or send a note.
