Single- and multi-lumen catheter extrusion, from process development through continuous improvement. The goal on every project is the same: translate device intent into a stable, scalable line.
Experience
Jonathan has worked in extrusion since 1993 and in custom medical extrusion since 2006, manufacturing catheter and medical device components. At Spectrum Plastics Group (formerly Apollo Medical Extrusion) he launched standardized French-scale catheter tubing and introduced high-temperature capability. As Director of Extrusion at Biomerics he oversaw the implementation of new extrusion processes at multiple locations.
The practice's process discipline covers single lumens, multi-lumens and profiles, across a material range from Pebax to PTFE.
The problems we solve
A multi-lumen die is not a cheap part. When it comes back wrong, you lose the tool cost, weeks of lead time and a slot on a line already promised to a program. Most of that traces back to decisions made before anyone cut steel. Interventional shafts routinely hold tolerances near plus or minus 0.0005 in, and some designs run walls under 0.002 in, so a septum that drifts or a lumen that goes oval is scrap, not a cosmetic issue. The usual causes:
- A die drawn as a copy of the target cross-section, with no allowance for die swell and draw-down
- Draw ratio balance (DRB) left off 1.0, producing uneven walls no line setting can correct
- Septa specified too thin to survive the melt, then collapsing or going oval
- A material picked after the tool, so the flow behavior fights the die
- Shared lumen air paths that let one channel distort another
What a design review covers
Before a drawing goes to the toolmaker, Jonathan reviews the cross-section, the draw-down ratio (DDR) and DRB math that should set the die dimensions, the septum walls, and the material fit. Pebax, TPU and nylon behave differently in the melt, and the die has to suit the resin. Each lumen needs its own regulated air supply: these systems run under 1 psi, often 0 to 3 inches of water, and a shift as small as 0.1 inch of water can throw dimension, so the pin should have independent air paths from the start.
How to start
Send the cross-section and target dimensions and Jonathan will review it with you before you cut steel. Book a 30-minute intro call or send a note. You'll hear back from Jonathan directly.
Related materials
Related reading
Have a part, a material question, or a line to scope? Book a 30-minute call with Jonathan or send a note.
