01 / Story 02 / Specialty 03 / Blog 04 / Contact
// SP.03 · SPECIALTY POLYMER FLOW SOLUTIONS

Melt fluoropolymer extrusion

FEP, PFA and ETFE for heat shrink, jacketing and engineered tubing. Process know-how across the melt-fluoro family, and when paste PTFE is the right answer instead.

Experience

Melt fluoropolymers are one of the six specialty areas of the practice, inside a material range that runs from Pebax to PTFE.

Melt fluoropolymers vs. PTFE

Most engineers meet fluoropolymers through PTFE, and PTFE colors the whole conversation. PTFE has a melt viscosity so high that it never flows like a normal thermoplastic; it is paste extruded and sintered. FEP, PFA and ETFE keep most of the chemical inertness, lubricity and temperature tolerance people want from PTFE, but they flow when heated. They run on conventional single-screw lines, hold tight tolerances, and make heat-shrink products PTFE cannot. That one distinction changes tooling, economics and options.

Choosing the resin

  • FEP: melts around 250 to 270°C, continuous use near 200°C. Clear, lubricious, easiest to process and usually the least expensive
  • PFA: fully fluorinated, melts around 300 to 310°C. Closest to PTFE, for hot fluid paths, flexing parts or PTFE-grade chemical resistance
  • ETFE: melts near 270°C. The tough one, with better impact and abrasion resistance than PTFE, but less clear and less soft than FEP

Heat shrink and fusing sleeves

FEP dominates medical heat shrink, with ratios around 1.3:1 to 2:1 recovering at roughly 190 to 210°C. The most common job is the catheter fusing sleeve: FEP over a jacket-and-liner stack, heated until it recovers and consolidates the build. Sizing, recovery ratio and recovery conditions have to match the shaft, or you get incomplete recovery or trapped voids.

The problems we solve

  • Picking FEP, PFA or ETFE for the actual service conditions
  • Keeping well under FEP's degradation point near 420°C, where it releases corrosive, toxic gas
  • Corrosion: fluoropolymer melts attack ordinary tool steels over time, so screws, barrels and dies need to be corrosion-resistant
  • Reusing one resin's profile for another; each runs at its own temperature
  • Gels, voids and dimensional drift from contamination on medical lines

How to start

Bring the requirements and constraints for a fluoropolymer extrusion, a heat-shrink fusing sleeve or a specialty tubing profile, and land on the right resin and a process that holds tolerance. Book a 30-minute intro call or send a note. You'll hear back from Jonathan directly.

Related materials

Related reading

// NEXT STEP

Have a part, a material question, or a line to scope? Book a 30-minute call with Jonathan or send a note.

← All specialties